I have made a few joints over past 10 years but this one works the best. It can hold even heavier arcraft without falling over even if you shake it.
Tools and stuff:
1. An epoxy glue (5 minutes 2-componet works the best)
2. drill with 5 mm drill bit
3. saw to shorten a peg
Thingies:
1. two pegs
2. 6-32 acorn nut - like this https://www.lbuytiq.com/index.php?ma...ucts_id=625309
3. a magnetic bed for the nut top - like this https://www.unimagnet.cz/kr-08-6-3-5-03-n_z229/
4. a tooth pick
Step by step:
See the picture below
1. Use a 5mm drill bit to drill down to the flat part of the nut till the ball top pops off.
Use a toothpick to spill an epoxy glue blob into the ball top and stick a shortened peg in. Let it dry.
2. Glue the magnetic bed on a peg.
3. Done.
Bookmarks