I'm hoping to start playing Wings of Glory WW1 in 2020 and have been buying some models to play 1918 games. Unfortunately one of the models had a crooked wing. Now I'm no model building expert but I did decide to give it a go at trying to fix the problem. Probably there is an easier way of fixing these issues? Any advice or suggestions would be gratefully received



The upper wing is going off at an angle on the left-hand-side when viewed in the above photo. Also, though not so evident in the photo, the tail is crooked and the tailplane is, again, angled to the left.

To say I was disappointed when I noticed these defects would be very accurate, and since there wasn't much that could be done - the seller wasn't at fault, its a manufacturing issue - I decided to have a go at fixing the issue.

It was harder than I imagined!



Cutting away the upper wing wasn't as easy as I'd hoped. But do-able. I used a razorsaw.

The tailplane, once removed with the razorsaw, was re-cut at an angle to meet the skew-whiff tail, then glued in place with superglue.

The upper wing was then positioned as-near-as-I-could-manage-straight back on the model. That wasn't easy, and that's an understatement. Swearing. Sweating. Glued-up fingers. Finally it ended up in a position I'm happy with. Never again! (hopefully)



I, also, replaced the plastic peg, that represents the pilot, with a metal miniature from Red Eagle Miniatures ...and then noticed that the plastic peg is connected to the inside floor of the model and I'd only gone and smashed out the bottom of the aeroplane. Doh! Luckily it was fixable.

[since these photos were taken I've done some more work on the metal pilot miniature. Broke it free of the glue, filed the miniature's bottom half so it wasn't as tall, reglued and placed back in the cockpit. Now the metal pilot figure doesn't sit as high in the cockpit as it first did.]



Quite a bit of superglue was needed to attach the upper wing - you can see the blobs in the above photo. Never mind. Maybe I can clean them up a bit before touching the paintwork up. If not, then they'll add strength to the glue join.

[the 'bit' hanging from the left-hand-side upper wing, in the photo, is the factory paintjob/camo decal. Its been reattached.]

I'll have to paint up the pilot miniature and I might, also, add some other painted details to personalise the miniature. Those are jobs for another day.