Albatros D.Va always sucked
The one from Neux/WoW was already bad ... Ares/WoG achieved the impossible: they made it worst
I've been trying different ways to improve it, including re-building from scratch using wire and clips. Results were good but hard working and time consuming
So I decided to ask Roman Vasyliev, a Shapeways' 3D designer (Kampfflieger models) to design some for me ... he did, and here are the results:
Comparison with Ares/WoG
Replaced Undercarriage: LEFT - Original ARES-WoG: on the RIGHT
Comparison with Neux/WoW
Original Neux-WoW: Black Udet's Albatros on the LEFT - Replaced Undercarriage: Hippel's on the RIGHT
I think these Shapeway's undercarriages are much better than both Ares/WoG and Neux/WoW ones.
The only problem they have is that they do not perfectly fit to the holes in the mini's fuselage: they are a little bit wider than they should be to match exactly. That is a minor problem since all Shapeways materials are flexible enough to bend the undercarriages struts and get them in position. Once in position.
I'll replace the undercarriages of all my Ares/WoG Albatross by these ones.
I'm not so sure about replacing the Neux/WoW ones since I think they are good enough
Bookmarks