3D printer can't be expected to turn out right every time
I found this intersting comic book in a newspaper shop:
The paintings are simply amazing, also the story is not bad, but I have to admit a bit historically questionable.
One of the airplane in the first pages is missing in Wings of War / Glory world: the AEG G.IV.
Thanks to this forum, I found this post,
so I start to look around to find a model to test the new resin 3D printer with something bigger than Fokker Dr.I.
Thingivers is one more time a really great source: https://www.thingiverse.com/thing:2553301
(many thanks to IngeniumCanada !).
From wikipedia I keep the wingspan is 18,4m / 144 = 127 mm
Really big for my printer that have an area of 120 x 68 mm.
I put it diagonally:
...but this morning, as the title of this post anticipate, I found a bad surprise:
The upper wing felt down in the resin basin
...and also the landing gear is not perfect.
I think that this time I can't recover this experiment in another flying junk....
Reply With Quote
Bookmarks