Building the Reviresco DH9.

[Flying Officer Kyte]

1. Clean off the flash

1. Make a copy of the wing jigs. Two glued together make a much firmer jig.

1. Cut out the wing jigs.

1. Drill all holes.
   
   
   
2. Glue on the lower wing. Ensure accuracy and angle to the body is 90 degrees.

1. Drill hole for the flight peg.

1. Fit wing jigs and top wing to the lower wing.

1. From a Paper clip, cut cabine struts and main struts to length.

1. Glue in place.

1. Fill holes and rub smooth with wet and dry paper.

1. Bend wire to make skids and fix into place.

1. Fit the undercart, but not the wheels.

1. Spray all parts with white primer undercoat.

1. Paint the parts.

1. Now fit the prop, wheels, Pilot, Observer, and radiator overflow.

1. Add decals using micro set and micro sol to fix.

1. Leave overnight to harden, and then varnish to taste.

This was a very easy construction thanks to the supplied wing jig.
You may also find it easier to make a simple former for the skids, although I just bent them with snipe nosed pliers.





Rob.

[Archidamus]

Nice and clear "how to" Rob, and a great-looking result too

[seagull]

Hmmm. You make it look all too easy. Thanks for the How-to, I just need to psych myself up to look at the pile of Red Eagle planes I've not touched in many years.

[marcoperse]

Perfect work Rob

Marco

[somaliavet]

As usual, a great how-to and excellent result. I am going to have to build a Reverisco sometime soon, because you make them look so easy!

[Lloydthegamer]

Very clean work and a great write up, thanks!

[Nick_ace]

Greta work Rob!!!A very clean and beautiful job!!!A nice "how to"!!!
Nick

[Grey Knight]

I agree you make it look easy

[freebird-52]

Very nice! Well laid out and to the point, great pics!

[Dan-Sam]

Every time I see such an easylooking How to article I want to leave my job and be a profi kit maker. Very interesting, thank you for sharing.

[Baron Rolf]

1. Clean off the flash

1. Make a copy of the wing jigs. Two glued together make a much firmer jig.

1. Cut out the wing jigs.

1. Drill all holes.
   
   
   
2. Glue on the lower wing. Ensure accuracy and angle to the body is 90 degrees.

1. Drill hole for the flight peg.

1. Fit wing jigs and top wing to the lower wing.

1. From a Paper clip, cut cabine struts and main struts to length.

1. Glue in place.

1. Fill holes and rub smooth with wet and dry paper.

1. Bend wire to make skids and fix into place.

1. Fit the undercart, but not the wheels.

1. Spray all parts with white primer undercoat.

1. Paint the parts.

1. Now fit the prop, wheels, Pilot, Observer, and radiator overflow.

1. Add decals using micro set and micro sol to fix.

1. Leave overnight to harden, and then varnish to taste.

This was a very easy construction thanks to the supplied wing jig.
You may also find it easier to make a simple former for the skids, although I just bent them with snipe nosed pliers.





Rob.

Nice " how to " Rob