BwanaJoe
My Gimbal Installation Method
by
, 02-16-2018 at 08:46 (5227 Views)
[QUOTE=BryanR;31627]I received my gimbals in the mail from Aerodrome Accessories. Now I just needed to figure out a good way to install them.
[ATTACH=CONFIG]241113[/ATTACH]
I was planing on gluing the ball part into the plane, and mounting the ring part on a stand like Col. Hajj suggests. I even ordered a bunch of extra ball bearings so I could switch out all my minis, and future minis with the ringed pegs. But I couldn't bring my self to drill into my minis, so I opted for the following solution.
I wanted a way to give the most realistic hinge point while maintaining the size of the peg, so the plane would be at the same height as a plane without a gimbal. Also so it would be obvious what altitude the plane was at if I ever decided to use the altitude rules. This is a highly technical mechanical drawing of my plan:
[ATTACH=CONFIG]241112[/ATTACH]
All I need to do was to put the gimbal inside the peg.
[ATTACH=CONFIG]241111[/ATTACH]
And like magic it is done! Click here to see the Detail of how it was done: [URL]http://www.wingsofwar.org/forums/showthread.php?p=31848#post31848[/URL]
[ATTACH=CONFIG]241107[/ATTACH]
Here it is on a stand, next to a normal stand:
[ATTACH=CONFIG]241110[/ATTACH]
Here it is with aircraft on the stands (do the heights look the same?):
[ATTACH=CONFIG]241108[/ATTACH]
Here are a couple of shots showing some of the angles:
[ATTACH=CONFIG]241109[/ATTACH]
[ATTACH=CONFIG]241114[/ATTACH]
After a small amount of time I was able to put together eight gimbals:
[ATTACH=CONFIG]241115[/ATTACH]
It is even strong enough to hold 2-seaters in position:
[ATTACH=CONFIG]241116[/ATTACH]
And now I can use them for both my WWI and WWII minis. (I don't have my WWII minis yet, so I had to use an aircraft from a later period):
[ATTACH=CONFIG]241117[/ATTACH][/QUOTE]