Related links:
- The thread about strips for card decks
- WWI - Strips for card decks in Files.
- WWII - Strips for card decks in Files.
OK, let's create!
- Prepare all the necessary tools: common knife, snap-off knife, scissors, rigid glue, ruler.
- Find the correct strip and carefully cut it out. It is much better to attach ruler from the side you want to protect from cutting off.
- Now you have just cut out strip. Now you need to create grooves for bending.
- See the grey lines and attach to them the ruler (may be about 0,5 mm from it - you must count with own thickenss of the knife).
- With a dull side of the blade swipe approximately five times over gray line. A little press, but not much.
- Now you have bended strip.
- Try the strip on the maeuvre deck without glue. Make sure that it fits exactly on the deck.
- Glue the edge part of the strip - be carefull, work with clean fingers.
- Carefully thread the strip back on the deck and slowly glue. So far, only lightly so you can make the corrections.
- When you're certain position, press your fingers and hold it few seconds.
- At the end of the work very carefully cut off the excess part.
- Now everything is done. Congratulations