• BUILDING THE REVIRESCO ALBATROS CIII.

    Clean up the casting.





    Glue on the bottom wing checking for squareness.





    Glue the cabine struts to the top wing.





    Drill out the wings for struts.
    Place the supplied jigs on the wings along with two temporary struts to align the setup.





    Glue the cabine struts to the fuselage.





    Strut the wings and glue into place.





    Fill and sand any blemishes left by the struts.
    Drill the peg hole.



    Glue on the Scarf ring.
    Position and glue on the undercart, but not the wheels.





    Glue the tailskid into place.





    Glue on the engine block exhaust horn.




    Add water pipe and gravity tank. (Optional)
    Undercoat spray all parts white.
    Paint the Body of the aircraft.





    Produce and print decals.





    Add painted Gunner, Pilot, and wheels.




    Micro set where needed and Decal the aircraft.




    After ten minutes, set into the body with Micro sol.



    Allow to dry overnight.
    Glue on the prop.
    Varnish to taste.



    Rob.
    This article was originally published in forum thread: BUILDING THE REVIRESCO ALBATROS CIII. started by Flying Officer Kyte View original post
  • Donations


    If you like our website and want to give something back, you can make a donation.

    Please select a preferred amount of the donation, and then click the poster image below.

    Donation Amount