- Clean off the flash
- Make a copy of the wing jigs. Two glued together make a much firmer jig.
- Cut out the wing jigs.
- Drill all holes.
- Glue on the lower wing. Ensure accuracy and angle to the body is 90 degrees.
- Drill hole for the flight peg.
- Fit wing jigs and top wing to the lower wing.
- From a Paper clip, cut cabine struts and main struts to length.
- Glue in place.
- Fill holes and rub smooth with wet and dry paper.
- Bend wire to make skids and fix into place.
- Fit the undercart, but not the wheels.
- Spray all parts with white primer undercoat.
- Paint the parts.
- Now fit the prop, wheels, Pilot, Observer, and radiator overflow.
- Add decals using micro set and micro sol to fix.
- Leave overnight to harden, and then varnish to taste.
This was a very easy construction thanks to the supplied wing jig.
You may also find it easier to make a simple former for the skids, although I just bent them with snipe nosed pliers.
Rob.