Flying Officer Kyte
10-22-2011, 01:34
Building the Skytrex Brandenburg W 29 Seaplane.
This is a very tricky little build due to the complex under frame assembly. Not one for a beginner.
254071. Clean up the casting.
2. Cut out the Camo decals (Not provided with the kit.) It is easy to draw around the wings at this stage.
25408
3. Glue on the wings. It is essential to get the holes aligned as inaccuracy can lead to endless trouble in fitting the under frame later.
25409
4. Spray the model with white undercoat.
5. Dry fit the undercart and floats.
25410
6. Glue on the undercart but NOT the floats or support struts.
25411
7. Paint all parts.
25412
8. Micro set the areas for camo decals to help adhesion.
9. Affix camo decals and after 10 minutes Micro sol for better conformity to the
surface undulations.
25413
25414
10. Fit and glue on floats and support struts.
25415
11. Add the recognition decals of choice. Again use the Micro set/sol routine.
25416
12. Glue on prop and gunner.
25417
13. Gloss varnish the model.
25421
14. Whilst this finish is in accord with the high gloss of seaplanes of the period, I finished the wings with matt varnish to subdue the reflective surface.
25420
25418
25419
Nb. The juxtapositioning of all the under frame parts and bending of the float pins to
position is a real pig of a job, and some fine tweaking and fettling is needed. If you have a degree in engineering you may succeed.
Rob.
This is a very tricky little build due to the complex under frame assembly. Not one for a beginner.
254071. Clean up the casting.
2. Cut out the Camo decals (Not provided with the kit.) It is easy to draw around the wings at this stage.
25408
3. Glue on the wings. It is essential to get the holes aligned as inaccuracy can lead to endless trouble in fitting the under frame later.
25409
4. Spray the model with white undercoat.
5. Dry fit the undercart and floats.
25410
6. Glue on the undercart but NOT the floats or support struts.
25411
7. Paint all parts.
25412
8. Micro set the areas for camo decals to help adhesion.
9. Affix camo decals and after 10 minutes Micro sol for better conformity to the
surface undulations.
25413
25414
10. Fit and glue on floats and support struts.
25415
11. Add the recognition decals of choice. Again use the Micro set/sol routine.
25416
12. Glue on prop and gunner.
25417
13. Gloss varnish the model.
25421
14. Whilst this finish is in accord with the high gloss of seaplanes of the period, I finished the wings with matt varnish to subdue the reflective surface.
25420
25418
25419
Nb. The juxtapositioning of all the under frame parts and bending of the float pins to
position is a real pig of a job, and some fine tweaking and fettling is needed. If you have a degree in engineering you may succeed.
Rob.