Flying Officer Kyte
06-14-2013, 03:52
Clean up the casting.
93664
Glue on the bottom wing checking for squareness.
93665
Glue the cabine struts to the top wing.
93666
Drill out the wings for struts.
Place the supplied jigs on the wings along with two temporary struts to align the setup.
93667
Glue the cabine struts to the fuselage.
93668
Strut the wings and glue into place.
93669
Fill and sand any blemishes left by the struts.
Drill the peg hole.
93670
Glue on the Scarf ring.
Position and glue on the undercart, but not the wheels.
93671
Glue the tailskid into place.
93672
Glue on the engine block exhaust horn.
93673
Add water pipe and gravity tank. (Optional)
Undercoat spray all parts white.
Paint the Body of the aircraft.
93674
Produce and print decals.
93675
Add painted Gunner, Pilot, and wheels.
93676
Micro set where needed and Decal the aircraft.
93677
After ten minutes, set into the body with Micro sol.
93679
Allow to dry overnight.
Glue on the prop.
Varnish to taste.
93678
Rob.
93664
Glue on the bottom wing checking for squareness.
93665
Glue the cabine struts to the top wing.
93666
Drill out the wings for struts.
Place the supplied jigs on the wings along with two temporary struts to align the setup.
93667
Glue the cabine struts to the fuselage.
93668
Strut the wings and glue into place.
93669
Fill and sand any blemishes left by the struts.
Drill the peg hole.
93670
Glue on the Scarf ring.
Position and glue on the undercart, but not the wheels.
93671
Glue the tailskid into place.
93672
Glue on the engine block exhaust horn.
93673
Add water pipe and gravity tank. (Optional)
Undercoat spray all parts white.
Paint the Body of the aircraft.
93674
Produce and print decals.
93675
Add painted Gunner, Pilot, and wheels.
93676
Micro set where needed and Decal the aircraft.
93677
After ten minutes, set into the body with Micro sol.
93679
Allow to dry overnight.
Glue on the prop.
Varnish to taste.
93678
Rob.