Flying Officer Kyte
08-21-2012, 04:03
Apart from the lack of a propeller this is another straight forward build suitable for a beginner.
57841
Clean up the castings.
Drill through the prop boss to fit prop (Not supplied with this kit).
57842
Make prop in two halves from plasticard.
Clear out holes for cabine struts, and wing struts.
Glue in cabine struts. Make sure they are the right way round.
Position wing struts and glue to bottom wing using top wing as a jig to ensure correct alignment.
57843
Glue on top wing, and re check alignment as it goes off.
57844
Fill any holes left in wings and then file and wet and dry to a smooth finish.
Turn plane upside down and assemble undercart.
57845
Align components and glue in place.
Temp position prop in holes of boss and spray plane with primer.
57846
Paint plane.
Glue in the two halves of the prop blades.
Apply decals of choice using micro set and micro sol.
57849
Allow to set up over night.
Varnish in your choice of finishes.
57848
No real notes needed for this one. Wysiwyg.
Rob.
57841
Clean up the castings.
Drill through the prop boss to fit prop (Not supplied with this kit).
57842
Make prop in two halves from plasticard.
Clear out holes for cabine struts, and wing struts.
Glue in cabine struts. Make sure they are the right way round.
Position wing struts and glue to bottom wing using top wing as a jig to ensure correct alignment.
57843
Glue on top wing, and re check alignment as it goes off.
57844
Fill any holes left in wings and then file and wet and dry to a smooth finish.
Turn plane upside down and assemble undercart.
57845
Align components and glue in place.
Temp position prop in holes of boss and spray plane with primer.
57846
Paint plane.
Glue in the two halves of the prop blades.
Apply decals of choice using micro set and micro sol.
57849
Allow to set up over night.
Varnish in your choice of finishes.
57848
No real notes needed for this one. Wysiwyg.
Rob.