Ares Games

Reviresco Breguet 14B2

96th Aero Squadron, 1st (Day) Bombardment Group, American Expeditionary Forces
  1. Custom made - Breguet BR 14B2   96th Aero Sq v2 
 
Ivan Ware is a buddy who introduced my to board games and loves playing Wings of War!
  2. Custom made - Back of Card: 96th Aero Sq 
 
Crewdogs based on real crewmembers from the 96th Bomb Squadron who served in Desert Storm
  3. The finished undersides
  4. 14. Trim the sprue from the bottom of the pilot &  gunner
  5. Right rear quarter angle view
  6. Left rearquarter angle view
  7. and matching card made using Photoshop and some of the blanks found in the File Section
  8. d. However, I didn’t want to buy more paint so I settled for:  
i. Light Green –  Model Master’s Enamal Forest Green FS34127 
ii. Dark Green –  Model...
  9. b. I found one site listing the Federal Standard Numbers:   
i. Light Green –  34258 
ii. Dark Green –  34096 
iii. Light Brown –  30266 
iv. Dark...
  10. Step 13 - Color Scheme.  Since I’m going with the 96th Aero Squadron (American), started with the light colors then added to darker colors 
 
a. The...
  11. Step 12. Begin painting 
a. Again wash the model to rid any oils & FOD 
b.  Prime with white
  12. Step 9 - Assemble the landing gear and glue to the bottom wing & fuselage 
 
10. Then add the wheels 
 
11. Glue radiator assemble to the front of...
  13. Step 8 - Glue rear assembly to the tail of the aircraft
  14. Step 7 - Glue vertical tail to stabilizer and elevator
  15. Step 6 - Use a Dremel tool with a cutting wheel to trim the wires, putty & sand flush
  16. Step 5 - Make interplace struts from .025 wire 
a. Push the rode down through the hole in the top wing into the hole in the lower wing 
b. Glue in...
  17. Step 4 - Although the instruction say; “Cut, fold and glue the two wing jigs from the reverse side of this label’.  I used the same technique as I...
  18. Step 3 - Cut cabine struts from castings and glue them into slot in the bottom of the wing
  19. Step 2 - glue lower wing
  20. Step 1 - glue fuselage
  21. In the beggining...Wash parts to get rid of the model release agents
Showing photos 1 to 21 of 21