Ares Games

Reviresco Hanriot HD-1

9me Escadrille, Maj Willy Coppens of Belgium

My first mini build...with more to come!
  1. 9me Escadrille, Maj Willy Coppens of Belgium
  2. 9me Escadrille, Maj Willy Coppens of Belgium
  3. 9me Escadrille, Maj Willy Coppens of Belgium
  4. 9me Escadrille, Maj Willy Coppens of Belgium
  5. 9me Escadrille, Maj Willy Coppens of Belgium
  6. 9me Escadrille, Maj Willy Coppens of Belgium
  7. the other side showing the unit logo
  8. Still painting, but can see the unit logo
  9. still need to add more silver paint...
  10. Step 11 – hand painted the Prussian blue, silver undersides, black-yellow-red tail flash.
  11. Step 10 – cutout a masking tape stencil for the unit and placed it in position
  12. Step 9 – primed the model in white…
  13. Drilled out a hole for the flight stnad peg...
  14. IMG 3867
  15. Caption
  16. After clipping the wires, I used my Dermel tool to grid of the ends and make flush with the top of the wing.
  17. Step 7 – Assembled the landing gear struts, axle using the same thickness wire, and glued to the bottom. 
 
Step 8 – Glued the engine to the...
  18. from the rear...
  19. Step 6 – was to use wire to form the inter-plane struts.  I pushed .022m wire through the top and glued to the bottom wing.
  20. Step 5 – use the wing jigs to hold the upper wing into place while gluing the cabine struts to the fuselage
  21. Step 4 – was to add the pilot, but I skipped it also and waited until after painting the aircraft.  If you do, you'll need to trim the pilot to...
  22. Step 3 – cut out the wing jigs from the instruction sheet
  23. Step 2 – was to drill out the holes on the upper wing, but I glued the “W” cabine struts to the upper wing
  24. Step 1 – Attaching the bottom wing to the fuselage
  25. The kit...
Showing photos 1 to 25 of 25