I bought two new Set3 planes last night (R.E. 8 and UFAG). They are packaged very well, but is it too much?
Upon trying to remove my R.E.8 the lower wing pulled away from the struts. This is the second time this has happened to me mostly with the WWI planes.
I do not want to ruin the packaging, so it can be reused if I ever decide to sell my collection, but at the same time I do not want damaged minis because they are placed in there so tight.
I am not an engineer, but I would think the packaging tabs could be slightly smaller and still hold the mini securely. The second one I pushed the tab back with a hobby knife and it was still a tight fit getting the mini safely out.
The WWII planes are not as bad, but I did get a bent prop once because of the same issue.
Anyone else have this experience or thoughts on safely removing the planes?
Bookmarks