Would it be possible to cut a wedge out of the flame/smoke markers so that they could be pushed on the pegs rather than take the model off the mount and push on the markers from the top? Dutchy
Would it be possible to cut a wedge out of the flame/smoke markers so that they could be pushed on the pegs rather than take the model off the mount and push on the markers from the top? Dutchy
In short yes! It all depends on how accurate your sawing is, and how much slop you are prepared to put up with. If you cut an angled slot so that the marker is just able to pass the peg at its narrowest point, you can then snug it down onto the fatter part of the peg. The fit is critical. Be prepared for some failures.
Rob.
"Courage is the art of being the only one who knows you're scared to death."
Bookmarks